diy cnc & constructing an affordable cnc kit
by:Luteng CNC Parts
2020-09-18
Build x axis with plywood.
It\'s just a box.
You need to cut these pieces like the picture above 8 1/4x2 1/2 \"1 10x2 1/2\" 1 8x1 1/2 \"structure to make sure it is the perfect square.
Glue with gorilla in the corner.
The size of the Gorilla Glue is 3 times that of the original, so it should be used less.
Clamp the PVC pipe and let it dry overnight.
You need to cut the following plywood for the Z axis: A 3 1/2x5 \"one 4 1/4x3 1/2\" and a 4 1/2x2 1/2 \"cut two PVC pipes into 8 1/4 \".
There will be creases at the elbow, draw a pencil mark.
Measuring 3/4 \"from the top, you will have your center-point.
Drill holes on PVC elbows.
The holes should be as big as your shaft.
The table is 8x7 3/4 \".
Screw the table onto the PVC pipe.
Make sure everything is square.
Do not stick PVC pipes together.
Make sure everything slides freely.
You might have to adjust.
When installing the screw, the PVC pipe must be cut out.
Fix the nut using a pipe hanger.
It\'s just a box.
You need to cut these pieces like the picture above 8 1/4x2 1/2 \"1 10x2 1/2\" 1 8x1 1/2 \"structure to make sure it is the perfect square.
Glue with gorilla in the corner.
The size of the Gorilla Glue is 3 times that of the original, so it should be used less.
Clamp the PVC pipe and let it dry overnight.
You need to cut the following plywood for the Z axis: A 3 1/2x5 \"one 4 1/4x3 1/2\" and a 4 1/2x2 1/2 \"cut two PVC pipes into 8 1/4 \".
There will be creases at the elbow, draw a pencil mark.
Measuring 3/4 \"from the top, you will have your center-point.
Drill holes on PVC elbows.
The holes should be as big as your shaft.
The table is 8x7 3/4 \".
Screw the table onto the PVC pipe.
Make sure everything is square.
Do not stick PVC pipes together.
Make sure everything slides freely.
You might have to adjust.
When installing the screw, the PVC pipe must be cut out.
Fix the nut using a pipe hanger.
Custom message